4. Installation
4.1. NX-Wing
1. Remove screws:
-
Remove 4 screws on the front (Torx T10)
-
Remove 4 screws on the back (Torx T10)
-
Slightly loosen 2 screws on the back (Torx T10)
2. Lift the front panel off the base. Push the top corner of the lamp dimmer plate in slightly, while lifting the
front panel off the base.
3. Put the front panel behind the base. Make sure that the cabling is not damaged.
4. Remove the blind plate:
-
Remove 6 screws + washers from the base (Torx T10)
-
Remove 4 screws from the side (Torx T10)
-
Remove the blind plate
Page 4