Advertisement
1. Introduction
Due to the shortage of components some NX2, NX4, and NX-Wing controllers shipped without the SMPTE and MIDI
interfaces. This guide describes in detail how these interfaces are installed in these 3 controllers.
To register your device and receive the SMPTE/MIDI Kit free of charge please visit:
ESD or Electrostatic Discharge is one of the main causes of electronic defects, such that the defect may not be
immediately noticeable, but can pop up later, even months afterwards. ESD can ruin electronic components and
can cause significant additional costs. Therefor it is very important to follow the instructions below.
Be sure to be properly grounded before opening the controller:
-
If possible: Carry out the service at an anti-static workstation.
-
Wear a grounded anti-static wristband.
-
Touch a grounded conductor every few minutes to discharge any static buildup.
-
Hold components by their edges only. Do never touch the surfaces or any of the contacts of the PCBs.
Page 2
support.obsidiancontrol.com/timecodeparts
WARNING: ANTI-STATIC PRECAUTIONS
Advertisement
