NEC NP-NC900C-A Service Manual page 70

KEY PART REPLACEMENT (Method of disassembly/Photo taken from life)
1-16 R/G/B Signal Connector Module & FMT Adapter Board
Put R/G/B signal connector module on the desk. Loosen 3 grounding screws on signal connector
module, and then release R2/G2/B2 cable. Torque: 5~6 kgf-cm
Reverse the R/G/B signal connector module on the desk. Loosen 3 grounding screws on signal
connector module, and then release R1/G1/B1 cable. Torque: 5~6 kgf-cm
Loosen 2 screws on signal connector module, and then take the shield off. And, unplug 6 pcs
signal cables from FMT adapter board. Loosen 4 screws on FMT adapter board and take it off.
Torque: 5~6 kgf-cm.
"Confidential, Do Not Duplicate without written authorization from NEC."
5-19