Advertisement
2. Installation
1. Stick the supplied Mounting Sticker to the surface to mark the 3 screw
positions. Drill 3 holes on the surface and insert the supplied 3 Screw
Anchors into the screw holes. If you want to run the cable through the
surface, drill a hole within the 3 screw area.
2. To mount the camera to the surface, screw the Camera Base to the
surface using the supplied 3 Screws.
3. Connect the Power Cable to a 12VDC / 24VAC power source. Connect
the Video Output Cable to a monitor or DVR.
4. For the first time installation, check whether the camera is properly
focused. If not, you can manually adjust camera Zoom or Focus using
the supplied L-Type Wrench. On the bottom of the camera, find the
Zoom and Focus nuts. Using the supplied L-Type Wrench to adjust
camera Zoom or Focus.
3
Advertisement
