Panasonic CS-S9TKV Service Manual page 139

16.3.2 CU-S12TKV
1. Remove 5 screws of the Top Panel.
Screws
Screw
2. Remove the 6 screws of the Front Panel.
Screws
Screws
Screws
3. Remove the screw of the Terminal Board Cover.
4. Remove the Top Cover of the Control Board by 2
hooks.
Hooks
Top Cover
Control Board
Caution! When handling electronic controller, be careful of electrostatic discharge.
Top Panel
Screws
Fig.1
Front Panel
Fig.2
Terminal Board Cover
Screw
Fig.3
Remove 4 connectors
from electronic
controller
Remove
1 screw
Remove
2 connectors
from reactor
Remove earth wire
Remove the Terminal Cover
and 3 Terminal Compressor
Control Board
Electronic Controller
139
Remove 2 screws
Remove
3 earth wire
Remove 7 connectors
from terminal board
Fig.4
Compressor
Fig.5
Control Board
Fig.6