Panasonic CS-S9TKV Service Manual page 63

Replace the drain hose
Rear view for left piping installation
Drain cap
•
How to pull the piping and drain hose out, in case of the
embedded piping.
Apply putty or
caulking material
to seal the wall
opening.
PVC tube for drain
hose (VP-20)
PVC tube
for drain
hose
11.2.4 Connect the Cable to the Indoor Unit
1 The inside and outside connection cable can be connected without removing the front grille.
2 Connection cable between indoor unit and outdoor unit shall be approved polychloroprene sheathed 4 ×
2
1.5 mm flexible cord, type designation 245 IEC 57 or heavier cord.
3 Bind all the power supply cord lead wire with tape and route the power supply cord via the left escapement.
4 Remove the tapes and connect the connection cable between indoor unit and outdoor unit according to the
diagram below.
Terminals on the indoor unit
Colour of wires
Terminals on the outdoor unit
Recommended
length (mm)
Note:

Secure the connection cable onto the control board with the holder.

Ensure the colour of wires of outdoor unit and the terminal Nos. are the same to the indoor's respectively.

Earth wire shall be Yellow/Green (Y/G) in colour and longer than other AC wires for safety reason.
Connection cable
Drain hose
Adjust the piping
slightly downwards.
Connection cable
Piping
PVC tube (VP-65) for piping
and connection cable
PVC tube for drain hose (VP-30)
Cable
Piping
Indoor unit
72 mm
1
1
Recommended
length (mm)
This equipment must be properly earthed.
Piping
Drain hose
Drain hose
Sleeve for piping hole
•
In case of left piping how to insert the
connection cable and drain hose.
Drain hose
from main unit
(For the right piping, follow the same procedure)
2 3
Connection cable
2 3
Indoor & outdoor
Connection cable
Escapement
a b c d
35 35 35 55
WARNING
63
Connection cable
More than 1150 mm
Drain
hose
Cable
Piping
Terminal
Tape
Board
Holder
Indoor & outdoor
Connection cable
Outdoor unit
Earth Wire
longer than
others
AC wires
for safety
reason