Fcc Notice (Part 15 - Class B); Fcc Radiation Exposure Statement; Japan Indoor Use Statement; Japan Voluntary Control Council For Interference (Vcci) - Class B - Extreme Networks ExtremeWireless AP5010 Installation Manual

Regulatory and Compliance Information

FCC Notice (Part 15 - Class B)

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment uses, generates, and can radiate radio frequency energy and if
not installed in accordance with the operator's manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one of the following measures:
•
•
•
•
Warning
Changes or modifications made to this device which are not expressly approved by the party
responsible for compliance could void the user's authority to operate the equipment.

FCC Radiation Exposure Statement

Warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of 43
cm between the radiator and your body.

Japan Indoor Use Statement

For Japan, the AP5010 access point is restricted for indoor use in the 5150-5350 MHz band only.

Japan Voluntary Control Council for Interference (VCCI) - Class B

Reorient or relocate the antenna of the receiving devices.
Increase the separation between this equipment and receiving equipment.
Connect this equipment into an outlet on a circuit different from that to which the
receiving equipment is connected.
Consult the dealer or an experienced radio or TV technician for help.
FCC Notice (Part 15 - Class B)
ExtremeWireless™ AP5010 Access Point 21