Servicing Notes - Sony XAV-AX5600 Service Manual

XAV-AX5600
The SERVICING NOTES contains important information for servicing. Be sure to read this section before repairing the unit.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if the
heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow) than
ordinary solder so use caution not to let solder bridges occur
such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
REPLACING THE LITHIUM BATTERY (CR2025) OF THE
REMOTE COMMANDER
When the battery becomes weak, the range of the
remote commander becomes shorter.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replace only with the same or equivalent
type.
Lithium battery (CR2025)
Note on the lithium battery
Keep the lithium battery out of the reach of children. Should
the battery be swallowed, immediately consult a doctor.
4
SECTION 1

SERVICING NOTES

+ side up
IMPORTANT NOTE FOR REPAIRING
This unit might contain individual personal information that the
customer registered in the replaced old part because it installs the
handsfree function of BLUETOOTH.
Therefore, when repairing, because the data that the customer regis-
tered might disappear, get the approval of the customer beforehand.
If any of the following repair is performed, that data disappears.
• Complete DISPLAY board replacing
• Factory reset (Initialize)
Note: Be sure to destroy the replaced old DISPLAY board with a ham-
mer before dispose it.
NOTE FOR SECURITY FUNCTION
This unit does not use security function by password lock.
ABOUT INSTALLATION OF THIS UNIT FOR WORKING
Due to the structure of the unit, you cannot stably place it on flat
surfaces.
Stabilize the unit by placing a stand, etc. under it that is suitable for
your work.
Sony CONFIDENTIAL
For Authorized Servicer
stand, etc.
SYS SET