NOTE FOR REPLACEMENT OF THE EEP ROM (IC402)
The EEP ROM (IC402) contains all data by which the LCD screen is defined.
When the EEP ROM is replaced, the normal LCD screen will not appear.
It is then necessary to write the data into the EEP ROM.
Writing Method:
1. Turn off power to the connection box XA-113.
2. While holding the TEST switch (S407) down for more than 5 seconds, turn on power to the XA-113.
Then, release the TEST switch (S407).
3. Press the VOL– key on the remote controller for more than 2 seconds.
4. The EEP ROM data will be written and the normal test mode screen will appear.
After this, perform V COM voltage/position adjustment as well as VIDEO adjustment.
SECTION 1
SERVICING NOTES
XVM-H65
3