Liquid Crystal Display, Panel Sub Assy - Sony XAV-AX5600 Service Manual

XAV-AX5600
3-9.

LIQUID CRYSTAL DISPLAY, PANEL SUB ASSY

Note 1: When the liquid crystal display is replaced, be sure to refer the
"FLICKER ADJUSTMENT" on page 30, and perform it.
Note 2: Panel sub assy includes touch panel and KEY board.
When touch panel or KEY board is defective, replace panel sub
assy (exploded view: Ref. No. FP1) with new parts.
4 liquid crystal display
(See Note 1)
(See Fig. H)
• Note about installing the liquid crystal display
< Fig. H >
Touch panel FPC and flexible flat
cable (10 core) are visible.
flexible flat cable (10 core)
• How to install the frame
< Fig. I >
When installing the frame, align it with the groove of the panel sub assy.
guide line
(wide side)
Press.
frame
• How to bend of the LCD FPC
< Fig. J >
LCD FPC
top side
bottom side
front side
LCD FPC
Bending
area.
29
LCD FPC
(See Fig. J)
OK
top side
bottom side
touch panel FPC
guide line
(narrow side)
Press.
– Inner view –
liquid crystal display
2.6 cm (+ 0, - 0.1 cm)
Within the bending area.
Bending
area.
top side
3
5 frame
(See Fig. I)
NG
Touch panel FPC and flexible flat
cable (10 core) are not visible.
top side
Press.
Press.
panel sub assy
Bend.
LCD FPC
OK NG
Out of the bending area.
Sony CONFIDENTIAL
For Authorized Servicer
2 Move the flexible flat cable
(10 core) to the outer side.
front side
1 Move the touch panel
FPC to the outer side.
6 panel sub assy
(See Note 2)
Bend.
LCD FPC
1.5 cm
SYS SET