Nortel BayStack 100-S Install Manual page 48

48 Chapter 3 Installing the Instant Internet software
•
•
•
14 Type the inactivity timeout (in minutes) or use the default of 10 minutes.
The inactivity timeout saves connect-time charges during times when no one
is requesting Internet access. It specifies the number of minutes of inactivity
over the dial-up connection after which Instant Internet terminates the
connection. When you need access again, the Instant Internet unit
automatically reestablishes a connection in a few seconds.
If you enter a value of 0, the inactivity timer is disabled and the Instant
Internet unit maintains the connection regardless of whether or not there is
Internet activity. However, if the line becomes unavailable for any reason
other than inactivity, a connection must be reestablished.
You can also set the inactivity timeout in seconds rather than minutes. For
details, refer to Using the BayStack Instant Internet Management Software
Version 7.11.
15 Click OK.
The Enter ISDN Information dialog box opens
209226-B
Phone – Type the phone number that you use to connect to the Internet.
If you need to dial a prefix, for example, to get an outside line, enter that
prefix followed by a comma.
If your B channel has a different phone number, you can enter a
secondary phone number. Use a slash (/) to separate the two numbers. If
the exchange (first three digits) is the same for both numbers, you can
enter only the last four digits of the secondary phone number (for
example, 555-1212/555-1213 or 555-1212/1213).
User ID – Type the user ID you use to connect to the Internet.
Password – Type the password you use to connect to the Internet.
(Figure 11).