1
Figure 44
1. Spark-plug boot
2. Clean around the base of the spark plug.
Figure 45
3. Remove and discard the old spark plug.
Note:
You will need a ratchet wrench extension
to remove the spark plug.
4. Set the gap between the electrodes on a new
spark plug at 0.76 mm (0.030 inch) as shown
in
Figure
46.
Figure 46
1. 0.76 mm (0.030 inch)
5. Install the new spark plug, tighten it firmly, and
attach the ignition wire to the spark plug.
Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
G016645
1. Loosen the clamp fastener on the chute-support
g016645
G016646
g016646
1. Cable conduit
2. Cable clamp
2. Remove any slack in the cable by pulling the
3. Tighten the clamp fastener while holding the
Replacing the Drive Belts
If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
g001029
24
Note:
Ensure that the ignition wire snaps
completely into place on the spark plug.
plate until the cable is free.
Figure 47
cable conduit rearward.
cable in place.
1
2
3
g019021
g019021
3. Clamp fastener