Operating The Auger/Impeller Drive; Operating The Quick Stick - Toro Power Max 826 OXE Operator's Manual

Figure 28
Operating the
Auger/Impeller Drive
1. To engage the auger/impeller drive, squeeze
the right (auger/impeller) lever to the handgrip
(Figure 29).
Figure 29
2. To stop the auger and impeller, release the right
lever.
Important:
When you engage both the
auger/impeller lever and the traction lever,
the traction lever locks the auger/impeller
lever down, freeing your right hand. To
release both levers, simply release the left
(traction) lever.
3. If the auger and impeller continue to rotate when
you release the auger/impeller lever, do not
operate the machine. Check the auger/impeller
cable; refer to Checking and Adjusting the
Auger/Impeller Cable (page 21)
necessary. Otherwise, take the machine to an
Authorized Dealer for service.
WARNING
If the auger and impeller continue
to rotate when you release the
auger/impeller lever, you could seriously
injure yourself or others.
Do not operate the machine. Take it to an
Authorized Service Dealer for service.
Operating the Quick Stick®
Hold the blue trigger cap down to use the Quick Stick
to move the discharge chute and the chute deflector.
Release the trigger cap to lock the discharge chute
and chute deflector into position
g001012
Moving the Discharge Chute
Hold the blue trigger cap down and move the Quick
Stick to the left to move the discharge chute to the
left; move the Quick Stick to the right to move the
discharge chute to the right
g001013
and adjust it if
•
•
•
16
Figure 30
Figure 31
If the chute does not move, refer to
Discharge-Chute Latch (page
If the chute does not turn as far to the left as it
does to the right, ensure that the cable is routed to
the inside of the handles. Refer to
Upper Handle (page 6).
If the chute does not lock into place when you
release the trigger cap, refer to
Discharge-Chute Latch (page
(Figure 30).
g001014
(Figure 31).
g018894
g018894
Adjusting the
24).
1 Installing the
Adjusting the
24).