Product Overview
Figure 15
1. Handgrip (2)
2. Auger/impeller lever
3. Speed-selector lever
4. Quick Stick®
discharge-chute control
5. Traction lever
6. Fuel-tank cap
7. Oil-fill tube/dipstick
8. Chute deflector
1
2
3
4
Figure 16
1. Primer
2. Ignition switch
3. Choke
4. Fuel-shutoff valve
g018887
9. Discharge chute
10. Scraper
11. Auger
12. Skid (2)
13. Electric-start button
14. Electric-start plug-in
15. Snow-cleanout tool
ST OP
G016500
5. Throttle
6. Oil-drain plug
7. Recoil-start handle
1. Snow-cleanout tool (attached to the handle)
Operation
Before Operation
Before Operation Safety
•
For electric-start models only: Use extension
cords and receptacles as specified in the manual.
Thoroughly inspect the electrical cord before
plugging it into a power source. If the cord is
g018887
damaged, do not use it. Replace the damaged
cord. Unplug the power cord whenever you are
not starting the machine.
•
Wear adequate winter garments whenever
you operate the machine. Wear substantial,
slip-resistant footwear that improves footing on
slippery surfaces. Avoid loose-fitting clothing that
can get caught in moving parts.
•
Always wear eye protection during operation or
while performing an adjustment or repair to protect
your eyes from foreign objects that the machine
may throw.
•
Thoroughly inspect the area where you will use the
machine, and remove all doormats, sleds, boards,
wires, and other foreign objects.
5
•
If a shield, safety device, or decal is damaged,
illegible, or missing, repair or replace it before
6
beginning operation. Also, tighten any loose
fasteners.
7
g016500
11
Figure 17
g004217