Shutting Off The Engine; Operating The Traction Drive; Operating The Speed Selector - Toro Power Max 826 OXE Operator's Manual

Shutting Off the Engine

1. Move the throttle to the S
to the S position
TOP
shut off the engine by pulling the ignition key
outward to the middle position.
Figure 25
2. Wait for all moving parts to stop before leaving
the operating position.
3. Remove the ignition key to prevent accidental
starting.
4. Close the fuel shutoff valve by rotating it
clockwise (Figure
Figure 26
5. Pull the recoil starter 3 or 4 times.
Note:
This helps prevent the recoil starter from
freezing up.
position, and then
LOW
(Figure 25). You can also
G016505
26).
G016499
Operating the Traction
Drive
CAUTION
If the traction drive is not properly adjusted,
the machine may move in the direction
opposite of what you intended, causing injury
and/or property damage.
Carefully check the traction drive and adjust
it properly, if necessary; refer to
and Adjusting the Traction Cable (page 21)
more information.
Important:
If the machine moves when the
traction lever is in the released position, check the
traction cable; refer to
the Traction Cable (page 21)
g016505
to an Authorized Service Dealer for service.
1. To engage the traction drive, squeeze the left
(traction) lever to the handgrip
2. To stop the traction drive, release the traction
lever.
Operating the Speed
Selector
The speed selector has 6 forward and 2 reverse
gears. To change speeds, release the traction lever
and shift the speed-selector lever to the desired
position (Figure
each speed selection.
g016499
15
Checking and Adjusting
or take the machine
(Figure
Figure 27
28). The lever locks in a notch at
Checking
for
27).
g001011