sangiorgio SDR8 Use And Maintenance Manual page 23

7. Delayed start
The delayed start function is used to allow
delay the start of the drying cycle. It is acti-
vated by the key marked
select the delayed time at a resolution of
one hour. The possible values are from 0
to 24 hours of delay. This time is shown on
the display 10 .
If the button or other are not pressed for
about 5 seconds, the display 10 will show
"program duration + delayed time" as the
remaining time to complete drying.
8. Power on
The dryer is switched on by rotating the
knob located at the centre of the control
panel. Its rotation allows you to switch on
and select a drying programme without
starting the programme.
9. Condensation tank
The condensation water that forms in
course of drying and is collected in a con-
densation tank 9 . When it is filled to the
maximum level of the container, the indi-
cator light turns on. To cancel it, the
container must be emptied.
Remove the condensation tank by extract-
ing it with both hands.
WARNING!
Condensed water is harmful to both
people and animals. Do not drink the
condensed water.
. The user can
Transport the tank holding it horizontally so
as not to spill the water by holding it both at
handle and at the other end.
Empty the tank and put it back in the dryer.
Condensation water can be used (eg with
irons with steam boilers or air humidifiers).
As a precaution, before using the con-
densed water, filter it with a fine sieve or
a coffee paper filter to remove all the fluff
in order to avoid damaging the equipment.
Figure 5
Figure 7
23