Huawei SCharger-7KS-S0 User Manual page 14

5
Connecting Communications
Cables
If you use WiFi connection, ensure that the
installation area is within the coverage.
If you select wired connection, refer to the
following to connect communications cables.
In the following figure, the power cable is routed
in from the middle.
1. Seal unused power cable holes with rubber plugs.
2. Cut the cable rubber cover based on site
requirements and secure it to the communications
cable inlet.
3. Route the network cable through the left
cable hole at the lower part of the rear cover.
4. Connect the network cable to the FE port on
the rear side of the charger.
FE
4
x 3 x 1
1 1
2
Router
1
3
6
Completing the Installation
In the following figure, the power cable is
routed in from the middle and WiFi networking
is used.
1. Seal unused power cable holes with rubber
plugs.
2. Align the charger with its rear cover, and push
the charger downwards.
3. Tighten the screws at the bottom. (Use a TT20
insulated security torx torque screwdriver with
a torque of 2.0 N·m.)
2
"CLICK!"
x 4
12
1
1 1
3