Huawei SCharger-7KS-S0 User Manual page 11

3
Cabling in the Rear Cover
1. Switch off the upstream RCBO.
2. Use scissors to cut the rubber covers to fit the cable size. Rubber covers should tightly hold cables to ensure
sealing effect.
3. The cable stripping template is printed inside the carton. Use a wire stripper to strip the power cable based on
the template.
4. Select an appropriate cord end terminal based on the cable diameter, and crimp the cord end terminal to the cable.
5. Connect the power cable through the cable inlet based on the actual cable route. Squeeze the cable rubber
cover in the cable inlet. (If the cable diameter is 22±1 mm, you do not need to squeeze the cable rubber cover
in the charger. Attach it to the charger enclosure.)
Ring 5 (15.0±0.5)
Ring 7 (18.5±1)
Cable diameters supported
by the rubber cover (mm)
Power cable inlets
Communications
cable inlet
Ring 1
Ring 6 (16.5±1)
Ring 9 (22±1)
Rubber cover
Power cable
inlet
Stripping template
Left cabling
Middle cabling
Right cabling Bottom cabling
9