5.4
Re-starting the device
5.5
Operation mode
1
Figure 5-4 Operating panel
1 'Close tool' pushbutton
To re-start the device, use the same operating sequence for starting the
device (Section 5.2).
The device has one operation mode:
Manual
UNIFLEX-Hydraulik -
In the manual operation mode,
lower the push ram
by pressing the button
'Close tool' pushbutton ' (1)
When the crimping dimension has been
achieved or the button is release, the comprssion
die will automatically return to the top (automatic
return stroke).
32 – www.uniflex.de
Operation