Uniflex UA 4 Operation Manual page 21

Figure 3-3 Hit push ram to the back
Figure 3-4 Insert die half at the back
Figure 3-5 Insert die half at the front
crimping process are:

Fitting and workpiece match each other. The nominal di-
ameter of the workpiece must not deviate from the crimp-
ing diameter of the workpiece by over 3 mm, otherwise
there may be increased crimping conicity. Die sets may
be ordered from UNIFLEX-Hydraulik.

Mount the appropriate die set.
 Push the compression die backward to the stop – this
provides a large clearing in the device.
the first die half into the 4 grooves at the back.

at the front. Check whether all dies are fully inserted in
the grooves.
 Mark the fitting's plug-in depth on the hose.
 Mount the fitting on the hose in accordance with the plug-
in mark.
 Manually place a pre-fabricated workpiece into the de-
vice from below. (Minimum safe distance of 120 mm)
 Position and hold the workpiece in the device (minimum
safe distance of 120 mm).
Never like this!

21 – www.uniflex.de
UNIFLEX-Hydraulik -
The minimum requirements for an accurate
Place the second die half into the 4 grooves
Never position the die halves with an offset of 90
Pull the push ram forward to the zero position
Design and function
Place
o
.