Uniflex UA 4 Operation Manual page 22

Figure 3-6 Operating panel
'Close tool' pushbutton
Figure 3-7 Micrometer
until it engages.
 Check whether the push ram is positioned centrally
above the compression rings.
 Initiate the crimping process on the operating panel
('Close tool' pushbutton) and keep the button pushed un-
til the device automatically moves upward upon achiev-
ing the crimping dimension (automatic return stroke).
 Remove the workpiece from the device. (Minimum safe
distance of 120 mm)
 Check the correct positioning of the fitting and the crimp-
ing diameter.
You can use any Uniflex die set to crimp 0.4 to 0.6
mm smaller than the nominal diameter.
Use the micrometer to set the crimping diameter.

The scale has a setting range of -0.6 to 8 mm.
Each full 360° revolution of the micrometer thimble increases
or decreases the crimping diameter by 1mm.
reached after each crimping process. Adjust the micrometer
as appropriate.
Figure 3-8 Crimping diameter check
22 – www.uniflex.de
UNIFLEX-Hydraulik -
A holding time cannot be set.
Check whether the pre-set crimping diameter was
Design and function