Starting The Device; Stoping The Device - Uniflex UA 4 Operation Manual

5.2

Starting the device

Figure 5-2 Main switch ON
5.3

Stoping the device

Figure 5-3 Main switch
OFF
The prerequisites for starting the device are:

The device has been installed and commissioned proper-
ly by qualified staff (fitter and electrician).

The device is fitted with the proper die set. Dies, fitting and hose
match each other.

All tools and auxiliary materials have been removed from the de-
vice.

Only the operator is in the working area.Any emergency stop sit-
uations have been remedied.

The operator has been provided with the Operation Manual by the
owner, has read and understood it and will follow its instructions.

The operator is familiar with the relevant safety regulations.
 Start the device by turning the main switch to ON.
The device is activated.
 Fully complete the crimping process.
 Place the workpiece away from the device.
 Stop the device by operating the main switch.
The device is deactivated.
UNIFLEX-Hydraulik -
31 – www.uniflex.de
Operation