Liability Exclusion; Product-Specific Safety Information; Replacing The Filter Cartridge - Brita PURITY 450 Steam Instructions Manual

1 PURITY Steam replacement instructions
Before replacing the filter please read the handbook for the PURITY Steam filter system. There you
will find detailed information on operating and safety notes, maintenance, troubleshooting and tech-
nical data.

2 Liability exclusion

The filter must be replaced exactly in accordance with the information in these replacement instruc-
tions. BRITA assumes no liability for any damage, including consequential damage, arising from
incorrect use of the product.

3 Product-specific safety information

Note for people with kidney disease or dialysis patients: during the filter process, the potassium
content may be increased slightly. If you suffer from kidney disease and/or have to stick to a special
potassium diet, we recommend that you consult your doctor first.

4 Replacing the filter cartridge

Caution: Filter replacement and maintenance of the filter system may be carried out only by
!
specialist staff.
Caution: The PURITY replacement cartridge may only be used in combination with the pressure
!
vessel that has been specifically designed for its size. See page 3.
Caution: During the exchange, carefully examine all dismantled parts! Faulty parts must be
!
exchanged and dirty parts should be cleaned. Before replacing, please read the operating and safety
notes (Chapter 3). After storage and transport lower than 0°C the product must be stored with the
EN
original packaging open for at least 24 hours before commissioning at the ambient temperatures for
operation specified in the "Technical Data" table (Chapter 9).
Filter systems without a measuring and display unit
The filter cartridge must be replaced after 6–12 months and no later than 12 months after commis-
sioning regardless of the level of exhaustion of the filter system. If the capacity of the filter cartridge
has already been exhausted (Chapter 7), it must be replaced earlier.
Filter systems with a measuring and display unit
The filter cartridge must be replaced no later than 12 months after commissioning, irrespective of
the level of exhaustion of the filter system. If the capacity of the filter cartridge has already been
exhausted (Chapter 7), it must be replaced earlier.
If the cartridge is already exhausted, the capacity is indicated as being negative by flashing. No bars
are shown in the display.
If the monthly limit for the cartridge has been exceeded, this is indicated by the date flashing.
10