Closing The Housing; Variant A (Version With Knurled Screws) - Siemens CELSIUS M450 Replacement

10

Closing the housing

Variant A (version with knurled screws)

Fig. 4:
•
Hook the side cover into the upper and lower guide rail of the housing in the direction of
the arrow (1).
Make sure that the side cover is offset by approximately 2 cm (a).
•
Press the side cover onto the housing.
•
Push the side cover as far as it will go in the direction of the arrow (2).
Fig. 5:
•
Press the side cover onto the housing (1) at the rear and tighten the two knurled screws
(2) with the other hand.
•
Return the system unit to its original position.
•
Reconnect any disconnected cables (power cord, cables to external devices, etc.).
CELSIUS M450/440
Variant A (close side cover)
Variant A (tighten the two knurled screws)
TD00-400.841.40.02.02
01.08
General information
Page 10 of 52
CS SD SP/CO
1.4
0
Siemens
Medical Solutions