Preparing The Water Block For Installation - ekwb EK-Quantum Vector2 AMP/Trinity RTX 4090 ABP Set D-RGB User Manual

PREPARING THE WATER BLOCK FOR INSTALLATION

M3 x 10 AX1 SCREW
M4 x 20 DIN7984 SCREW
TERMINAL
BADGE
STEP 1
First, remove the terminal badge which is attached to the terminal
with two magnets. Under the badge, unscrew three (3) screws
M4 x 20 DIN7984. Additional seven (7) screws M3 x 10 AX1 need
to be removed (as shown in the image). Save the removed parts
for later use.
For this step, you will need:
Phillips Head Screwdriver
STEP 1
- 8 -
Allen Key 2.5mm