Table of Contents
Advertisement
Communication Ports
4.2.3 EoVDSL Performance
If the line conditions degrade (reducing the SNR or Signal to Noise Ratio), but the
device is able to maintain the link, an alarm will be triggered to notify the user of the
reduced SNR. By configuring the Rescan Mode parameter in RUGGEDCOM RS930L,
the user can control at which point the scan process will be restarted when the line
conditions degrade. If Link only is selected, the device will restart the scan process
if the line conditions degrade, such that the device is unable to maintain the current
link. If Link or SNR is selected, the device will restart the scan process if either the
SNR has dropped below a pre-defined acceptable level or when the device is unable
to maintain the current link, or whichever comes first.
Note
If the Mode parameter is set to Manual Mode, the restart of the scan process will
only attempt to attain the set speed in manual mode.
For information about configuring EoVDSL, refer to the "RUGGEDCOM ROS
Configuration Manual" for the RUGGEDCOM RS930L.
Note
Assuming the distance can support the speed setting, the time to establish a link is
typically 15 to 30 seconds.
Universal EoVDSL Performance Characteristics
On No. 24 AWG Polyethylene Insulated Cable (PIC) twisted-pair wiring, the following
performance is typical with Universal EoVDSL:
Long-Reach EoVDSL Performance Characteristics
On No. 24 AWG Polyethylene Insulated Cable (PIC) twisted-pair wiring, the following
performance is typical with Long-Reach EoVDSL:
22
Distance
0.5 km (1640 ft)
0.6 km (1969 ft)
0.7 km (2297 ft)
0.9 km (2953 ft)
1.0 km (3280 ft)
1.3 km (4265 ft)
1.7 km (5577 ft)
2.0 km (6562 ft)
2.5 km (8202 ft)
Distance (km)
0.50
1.00
1.50
Distance (ft)
Downstream (Master
to Slave) (Mbps)
1600
3300
4900
Downstream/Upstream (Mbps)
35
30
25
20
15
10
5
2.5
1.2
Upstream (Slave
to Master) (Mbps)
40
25
20
Installation Manual, 11/2022, C79000-G8976-1034-11
20
5
0.54
RUGGEDCOM RS930L
Advertisement
Table of Contents
