Advertisement
3-10
Functions
Power ON
+
1
1 s min.
MODE
Timing Charts
Output mode A Mode: Signal ON-Delay (Timer resets when power comes ON.)
Power
Start signal
Gate
Reset
Control output
Set value
UP
0
Timing
diagram
Set value
DOWN
0
Publication 700-UM002A-EN-D - July 2001
To change the mode to timer/twin timer selection mode, hold
down the
The
MODE
If the
Select either timer operation or twin timer operation
Timer/Twin timer
using the
selection
Note:
Note:
1. When the mode is changed to timer/twin timer selection mode, the present
value is reset and output turns OFF. Timing operation is not performed in
timer/twin timer selection mode.
2. Setting changes made in timer/twin timer selection mode are enabled when
the mode is changed to run mode. If settings are changed, the 700-HX is
automatically reset (present value initialized, output turned OFF).
The gate input is not included in the 700-HX.
One-shot
Sustained output
t
t
key for 1 s min. with the
1
key must be pressed before the
key is pressed first, the mode will not change.
1
keys.
The 700-HX is
factory-set for timer operation.
One-shot outputs can be to set to 0.1 s, 0.5 s, 1s, 5 s, 10 s, 20 s.
Timing starts when the start signal goes ON.
While the start signal is ON, the timer starts when
power comes ON or when the reset input goes OFF.
The control output is controlled using a sustained or
one-shot rime period.
Basic Operation
Start signal
t
input
* Output is instantaneous when setting is 0.
** Start signal input is enabled during timing.
1
key held down.
MODE
key.
1
Power
**
Timing
Output
Advertisement
