Infineon XENSIV BGT60LTR11AIP Manual page 8

XENSIV™ BGT60LTR11AIP Radar Shield2Go
Super low-power 60 GHz Doppler radar sensor with antennas-in-package
Getting started
Figure 5 Shield2Go connector S1 schematics
After that, connect the microcontroller board via USB to your computer and continue with the software setup as
described in section 4.
Note: By using Infineon's
Rev3 form factor due to the integrated level shifter on the adapter. The adapter works with 5 V
(e.g., Arduino Uno Rev3) and 3.3 V shields (e.g., XMC1100 Boot Kit/XMC4700 Relax Kit). Please read
the MyIoT adapter manual for more details on how to configure the voltage shifting.
The following boards are recommended for use and are compatible with the Arduino IDE and Platform.IO.
Figure 6 Recommended boards
Application Note
MyIoT adapter, you can easily plug up to three Shield2Gos on an Arduino Uno
page 8 of 32 V1.0
2022-12-15