Software Setup; Required Software For Infineon's Xmc™ Boards; Required Software For Arduino; Installation Instructions For Xmc™ Microcontrollers - Infineon XENSIV BGT60LTR11AIP Manual

XENSIV™ BGT60LTR11AIP Radar Shield2Go
Super low-power 60 GHz Doppler radar sensor with antennas-in-package
Getting started
3.3

Software setup

3.3.1 Required software for Infineon's XMC™ boards
Segger J-Link, either for Windows or Linux (for XMC™)
•
Arduino IDE, either for Windows or Linux
•
XMC-for-Arduino (installed with Arduino IDE)
•
Radar BGT60LTR11 Library
•
v2.0.0 or higher)
1) Install Arduino
2) Install XMC™
but other third-party boards such as the Infineon XMC™ MCU-based board need to be explicitly
included. Follow the instructions in the
3) Install the
Manager. Type
4) Additionally, install Segger J-Link if you are using an Infineon XMC1100 Boot Kit or XMC4700
Relax Kit. Continue with the section below if you are using Infineon's XMC™ microcontroller for
Arduino.
3.3.2

Required software for Arduino

Arduino IDE, either for Windows or Linux
•
Radar BGT60LTR11 Library
•
v2.0.0 or higher)
1) Install Arduino
2) Install the
Manager. Type
3) Additionally, install Segger J-Link if you are using an Infineon XMC1100 Boot Kit or XMC4700
Relax Kit. Continue with the section below if you are using Infineon's XMC™ microcontroller for
Arduino.
3.3.3 Installation instructions for XMC™ microcontrollers
You can also find the whole XMC-for-Arduino installation guide for Infineon's XMC™ repository on GitHub.
3.3.3.1

Prework for SEGGER J-Link

In order to use and program the Infineon XMC™ microcontrollers in the Arduino IDE,
installed on your PC. Please follow this link to
documentation pack for your operating system. If you have already installed
for XMC™ Microcontrollers
your system.
Application Note
for Arduino on Infineon's GitHub repository (installed with Arduino IDE,
IDE. If you are new to Arduino, please
board. The official Arduino boards are already available in the Arduino software,
library. In the Arduino IDE, go to the menu
BGT60LTR11 and install the library.
for Arduino on Infineon's GitHub repository (installed with Arduino IDE,
IDE. If you are new to Arduino, please
library. In the Arduino IDE, go to the menu
BGT60LTR11 and install the library.
SEGGER J-Link
you can skip this step, as the respective drivers/programs are already installed on
download
link to add the XMC™ board family to Arduino.
Sketch > Include library > Library
download
Sketch > Include library > Library
and install the J-Link software and
page 10 of 32
the program and install it first.
the program and install it first.
SEGGER J-Link must be
DAVE™ – Development Platform
V1.0
2022-12-15