Scanning Originals Applied With Auto Focus - Microtek Bio-5000 Plus Supplement Manual

Scanning Originals Applied with Auto Focus

By default, the Auto Focus function is
activated when your Scan Material is set as
Transmissive. It is disabled when your
Scan Material is set as Reflective. If you like
to apply the Auto Focus function to your
reflective originals, you need to go to the
Preferences menu and to select the More...
command, and then check the Auto Focus
to activate this function.
1. Follow steps 1 to 3 in the previous scanning scenarios to place your scan material,
and to launch ScanWizard Bio.
2. Click the Overview button to perform a preliminary scan of the image.
If this is the first time to scan your scan material, you can see a flashing frame
(enclosed by dotted lines) together with a default Auto Focus target sign (
appearing on the preview area. The Auto Focus target sign marks the area where
the Auto Focus is applied to.
3. To apply the Auto Focus function to the image, use either of the ways below:
• The area applied with the Auto Focus function is decided and selected by the
software system automatically.
Click the Overview button to perform a preliminary scan of the image, which
will appear in the Preview window. Immediately, you can see a target sign ( )
appearing on the overview image. The target sign marks the area where the
Auto Focus is applied to. In this case, the software system automatically
detects, calculates and selects the area applied with the Auto Focus function.
Auto Focus target
sign
Scan frame
(enclosed by dotted
lines)
Bio-5000 Plus Supplement
)
13