Table of Contents
Advertisement
Otto is very well designed for 3D printing, so won't give you trouble if you follow this common parameters:
• Recommended to use a FDM 3D printer with PLA material.
• No need supports or rafts at all.
• Resolution: 0.15mm
• Fill density: 20%
Notes:
You can print individually piece by piece to match the colors of the original design or optionally print all at the same
time in an area of 14cm x 14cm.
For slicing and generating the g code for the machine free slicer software like Cura or FlashPrint that comes with the
FlashForge Finder 3D printer that we are using (If you are outsourcing the printing, no need to worry about it)
After printing, you will need to clean a little bit the legs and feet areas that fix the motors.
CHAPTER
FOUR
4.PRINT SETTINGS
9
Advertisement
Table of Contents
