Table of Contents
Advertisement
Self-balancing Car
5.3 Step3: Fix Servos to Body
Take the other 2 micro servos put them in the defined locations in the 3D printed body, and fix them only with screws.
5.4 Step4: Fix Legs to Body
Connect the legs to the hub of the micro servo, important like the foot servos, you must check the legs are able to rotate
180 degrees each side respect to the body.
After verifying the alignment, fix them using the small screws to the hole inside the leg.
5.3. Step3: Fix Servos to Body
17
Advertisement
Table of Contents
