Table of Contents
Advertisement
Safety requirements
When operating: below 3,000 meters.
When not operating: below 15,000 meters.
Installation (over voltage) Class This product is powered by a main power source that
complies with Installation (over voltage) Class II.
Warning:
Make sure that no overvoltage (such as that caused by lightning) reaches the
product. Otherwise the operator may be in danger of receiving an electric shock.
Installation (overvoltage) Class definition
Class I refers to the signal level, which is applicable to the measuring terminal of the
instrument connected to the source circuit. Measures have been taken to limit the
instantaneous voltage to the corresponding low level.
Class II refers to the local distribution level, which is applicable to instruments connected
to the mains (AC) supply.
Degree of pollution
Class 2
Pollution level definition
⚫
Level 1: No pollution, or only dry non-conductive pollution. This pollution level has
no impact. For example: clean room or air-conditioned office environment.
⚫
Level 2: Generally, only dry non-conductive pollution. Temporary conduction due to
condensation may sometimes occur. For example: general indoor environment.
⚫
Level 3: Conductive pollution, or dry non-conductive pollution becoming conductive
due to condensation. For example, an outdoor environment with a canopy.
⚫
Level 4: Permanent conductive pollution through conductive dust, rain, or snow.
For example: outdoor places.
Security level
Level 1 - Grounded products
1.5
Maintenance and cleaning
Maintenance:
Do not make the LCD exposed to direct sunlight for a long time when placing the
oscilloscope.
Cleaning:
Regularly check the oscilloscope and probe according to the requirements of the
operating conditions, please follow the following steps to clean the outer surface of the
HDG3000C Quick Guide
4
Copyright © Qingdao Hantek Electronics Co., LTD
EN
Advertisement
Table of Contents
