Preparation Before Assembling; Engraving; Sanding; What To Expect Reading The Assembly Instructions - Ultimaker Original+ Manual

By 3dkanjers

Hide thumbs Also See for Original+:

Table of Contents

Preparation before assembling

4.1

All panels are marked with the side they belong to.

For all the panels except the FRONT panel and the BOTTOM panel, the

engraving faces. The FRONT panel has the "Ultimaker" engraving facing

outward. The BOTTOM panel has the engraving facing downward.

4.2

Before starting the assembly, you may want to sand the panels slightly to

remove any burn marks/blemishes from the laser cutting process. You can also

paint or stain your Ultimaker Original+. Be aware that paint will not cover the

brown cutting edges very well.

What to expect reading the assembly

instructions

5.1

Before assembling the Ultimaker Original+, separate sub assemblies have to be built.

The description of every sub assembly in this manual will contain:

• An overview of the needed tools;

• An estimation of the needed time to built the sub assembly;

• The steps;

Every step in this manual will be described using the following structure:

• Cautions and warnings (if applicable);

• The needed parts;

• The actions to perform the step.

To make this manual easy to understand, images are used as much as possible.

Table of Contents