Setting And Operation; Safety Instructions - Burkert 8756 BATCH Operating Instructions Manual

Type 8756 BATCH

Setting and operation

8 SETTING AND OPERATION
8.1

Safety instructions

DANGER!
Risk of injury that is due to pressure in the installation or in the product.
Before working on the installation or product, cut the pressure. Vent and drain the pipes.
DANGER!
Risk of injury from electric shocks.
Before working on the installation or product, switch off the power supply. Make sure that nobody can
switch the power supply on.
Observe all applicable accident protection and all applicable safety regulations for electrical equipment.
DANGER!
Burn hazard and fire hazard that are due to hot surface of the product.
Do not touch the hot surface with bare hands.
Wear safety gloves to touch the product.
Keep the product away from any highly flammable materials or fluids.
WARNING!
Risk of injury that is due to escape of the fluid.
Contact with the operating fluid, its reaction products and vapours can cause injuries.
Inhaled vapours can be harmful.
Observe all applicable accident protection and all applicable safety regulations relating to the operating
fluid used.
WARNING!
Risk of injury that is due to improper operation.
Improper operation can lead to injuries and damage to the product and its environment.
The operating personnel must have read and understood the content of the Operating Instructions.
Observe the safety information and the intended use.
Only properly trained personnel may operate the installation and the product.
Only properly trained personnel may change parameters with the help of the Bürkert Communicator
software.
NOTICE!
When the product is flushed, flushing fluid can remain in the product.
If different fluids flow through the same pipe, then take into account their chemical compatibilities.
If a new fluid flows through the pipe, then it can mix with residues of the previous fluid.
29