Seagull Models Cessna L-19A Bird Dog Assembly Manual page 30

Cessna L-19A Bird Dog
"Old Dog, New Tricks" 35-40cc - 98" wingspan
When you are sure that everything is
aligned correctly, mix up a generous
amount of Flash 30 Minute Epoxy. Ap-
ply a thin layer to the mounting slot
and to bottom of the vertical stabilizer
mounting area. Apply epoxy to the bot-
tom and top edges of the iller block and
to the lower hinge also. Set the stabilizer
in place and realign. Double check all of
your measurements once more before
the epoxy cures. Hold the stabilizer in
place with T-pins or masking tape and
remove any excess epoxy using a paper
towel and rubbing alcohol. Allow the
epoxy to fully cure before proceeding.
6.
ELEVATOR PUSHROD HORN
INSTALLATION
Install the elevator control horn using
the same method as with the aileron con-
trol horns.
Position the elevator control horn on the
both side of elevator.
1.
Elevator control horn
30
2.
3.
C/A glue
Hinge
4.
5.
Instruction Manual.
hread one clevis and M2 lock nut on
to each elevator control rod. hread the
horns on until they are lush with the
ends of the control rods.
Elevator and rudder pushrods assembly
as pictures below.
M2 clevis
Elevator pushrod
M3 clevis
Fuel tubing
M2 lock nut
Hex nut