Transport And Installation; Transport - CompAir L15 Operating And Service Manual

5. Transport and installation

5 Tr ans por t an d i ns tall ati on
5.1

Transport

Fig. 6
Fig. 7
1 Wire pin
2 Hinge pin
Note
The wire pins (-1- Fig. 7) and the doors must be
removed prior to transportation.
Danger
The compressor must be lifted using a
suitable forklift truck which complies with
the local safety regulations.
The length of the forks must correspond at
least to the width of the unit (see Chapter
11.2).
Before lifting, all loose or slewable parts of
the machine have to be firmly secured.
It is strictly prohibited to work or stand in
the danger zone of a lifted load.
The proper lifting of the load (according to
the operating instructions of the load
suspension device) has to be ensured.
Important
Never lift or lash the compressor and its hood via
the enclosure. The screw compressor is lifted with
the help of a fork lift truck (Fig. 6). The separation
of the forks and their length must be taken into
account for transportation.
Only use the identified lifting points. Do not slide
the unit when it is standing on the floor.
Weights
The values listed below are approximate values, they
refer to a screw compressor unit including oil fill:
Air-cooled unit
L90 A
L110 A 2614 kg
L132 A 2778 kg
L140 A 3254 kg
L90RS A 2768 kg
L110RS A 2786 kg
L132RS A 2786 kg
Water-cooled unit
L90 W 2377 kg
L110 W 2478 kg
L132 W 2599 kg
L140 W 3075 kg
L90RS W 2327 kg
L110RS W 2361 kg
L132RS W 2361 kg
50 Hz 60 Hz
2513 kg 2518 kg (5551 lbs)
2658 kg (5860 lbs)
2778 kg (6124 lbs)
3254 kg (7174 lbs)
2768 kg (5514 lbs)
2786 kg (6768 lbs)
2786 kg (6142 lbs)
50 Hz 60 Hz
2382 kg (5251 lbs)
2483 kg (5474 lbs)
2602 kg (5736 lbs)
3078 kg (6786 lbs)
2327 kg (5130 lbs)
2361 kg (5205 lbs)
2361 kg (5205 lbs)
25