Table of Contents
Advertisement
the process is complete. If the driver is not automatically found, contact Brech-
tel.
10. The installer will also create a new directory C:/Auto Collector which will con-
tain the "BMI-Auto Collector v1.1.exe" software.
11. Installation of all software should now be complete. Before running the BMI
PILS 4001.exe software, it is important to verify the COM port numbers that
have been assigned to the USB-to-serial and USB-to-RS485 converters that
were installed, see the next step.
12. In the control panel from the Windows Start Menu, choose Settings and then
System.. In the search box type "Device Manager". In Device Manager expand
the 'Ports' menu. The USB-RS485 converter should be shown with its assigned
COM port number. Make a note of the port number so the correct COM port can
be assigned in the BMI PILS 4001.exe software. The converter used for the tem-
perature controllers is often named 'USB Serial Port (COM#). The PILS soft-
ware will not operate correctly unless the correct COM port value is used. If you
enter the wrong COM port in the software, don't worry, just change the value.
13. Perform the same search as described above in Device Manager for the USB-
to-Serial converter cable used with the Auto-collector so the correct COM port
number can be entered in the Auto-collector software.
7.7 Rack Mounting
The rack mount ears shall be attached to the sides of the chassis using the bolts provided.
The ears shall be attached to the rack using a minimum of four 10-32 bolts as shown in
the figure below.
83-00009-01A
PILS 4001-115V and 4001-230V
7.7 Rack Mounting
Page 47 of 74
Advertisement
Table of Contents
