Wolf Sub-Zero ICB400 Series Service Manual page 78

International W
International W
Drawer Assembly Removal (Model ICB427R Only)
There are inverted channels on both sides of the draw-
er tubs which rest on telescoping drawer slide assem-
blies. A pin at the front of each drawer slide fits into a
hole in the inverted channel of each drawer tub, holding
the drawer assembly in place.
Top drawer has a display wire harness that must
be disconnected during top drawer removal.
Failure to disconnect wire harness could damage
wiring or connections. See top drawer assembly
removal procedure below.
Top Drawer Removal:
1. Pull top drawer assembly open 6 to 10 inches.
2. Lift front of drawer up and off of pins at end of
drawer slides, then push slides back in
(See Figure 7-2).
3. Carefully place drawer assembly face down directly
in front of unit.
4. Disconnect control cable at interior left rear of unit
by turning collar on connector counterclockwise and
unplugging pins from socket
Bottom Drawer Removal:
1. Pull bottom drawer open and lift front up and off of
pins at end of drawer slides
2. Continue pulling drawer assembly forward and out.
Then, push telescoping drawer slide assemblies
back in.
Door & Drawer Gasket Removal
(Models ICB427 & ICB427R)
The door and drawer gaskets are pressed into retaining
channels that are molded into door and drawer liners.
NOTE: Drawer assemblies must be removed from the
unit in order to remove and/or install their gaskets.
To remove a door or drawer gasket, simply pull the gas-
ket dart from the retaining channel.
ine Storage
ine Storage
(See Figure 6-33)
(See Figure 6-34).
(See Figure 6-33).
(See Figure 6-35)
Series
Series
Component Access / Removal
(ICB400)
(ICB400)
Hole in Channel
Figure 6-33. Drawer Assembly Removal
Figure 6-34. Disconnecting Control Cable
Channel
Figure 6-35. Gasket Removal
6-15
Drawer Assembly
Drawer Slide
Turn collar
counterclockwise
to disconnect
Gasket
7011544 - Revision A - November, 2008
Pin