Wolf Sub-Zero ICB400 Series Service Manual page 13

Installation Information
Overlay Door Panel Removal and Installation
(ICB424)
Overlay panels are attached to the door using screws
passing through the door frame from the rear, into the
panel. The handle may also be attached through the
door frame or just through the panel.
To Remove an Overlay Panel:
1. Open door.
2. Remove Poly-tape under gasket which covers
panel mounting screw holes
NOTE: Do not discard tape. It must be reapplied
when panel is reinstalled.
3. Extract panel mounting screws, and possibly handle
mounting screws. (See Figure 2-16)
4. Pull overlay panel from door.
NOTE: To install overlay panel, reverse steps above.
7011544 - Revision A - November, 2008
International W
International W
(See Figure 2-15).
ine Storage
ine Storage
(ICB400)
(ICB400)
Door Frame
Figure 2-15. Poly Tape Removal
Overlay Panel
SS Handle Shown (Handle may vary)
Figure 2-16. Overlay Door Panel Removal
2-8
Series
Series
Door Gasket
Poly Tape
Door Assy
Poly
Tape
Panel
Mounting
Screws