Wolf Sub-Zero ICB400 Series Service Manual page 14

International W
International W
Door Panel Removal and Installation
(ICB427 & ICB427R)
Models ICB427 and ICB427R are NOT supplied with
panels from the factory. Panels are purchased sepa-
rately. Door panels are attached with screws passing
from the rear through the door frame into the panel.
The handle is attached to the panel.
To remove a door panel:
1. Open door.
2. Remove Poly-tape under gasket which covers
panel mounting screw holes
NOTE: Do not discard tape. It must be reapplied
when panel is reinstalled.
3. Extract panel mounting screws.
4. Pull panel from door.
NOTE: To install panel, reverse steps above.
Drawer Panel Removal and Installation (ICB427R)
NOTE: Model ICB427R is NOT supplied with panels
from the factory. Panels are purchased separately.
Drawer panels are attached using screws passing
through mounting brackets at the bottom of each draw-
er, and a dog-eared bracket on the back of the panel fit-
ting into slots in the face of the drawers. Handles are
attached to the panels.
To remove a drawer panel
1. Open drawer.
2. Extract the six screws at bottom drawer panel
bracket.
3. Pull bottom of drawer panel out slightly while pulling
downward.
NOTE: To install panel, reverse steps above.
ine Storage
ine Storage
(See Figure 2-17).
(See Figure 2-18)
(See Figure 2-19):
Series
Series
(ICB400)
(ICB400)
Door Frame
Figure 2-17. Poly Tape Removal
Figure 2-18. Door Panel Removal
Figure 2-19. Drawer Panel Removal
2-9
Installation Information
Door Gasket
Drawer Panel
Mounting Bracket
Drawer Panel
7011544 - Revision A - November, 2008
Poly Tape
- Upper
Mounting
Bracket
- Bottom