Models Icb427, Icb427R; Exterior Cosmetic And Mechanical Components - Wolf Sub-Zero ICB400 Series Service Manual

Component Access / Removal
MODELS ICB427 AND ICB427R EXTERIOR COSMETIC AND MECHANICAL COMPONENTS
Kickplate/Grille Removal (Models ICB427 &
ICB427R)
The kickplate/grille is attached by four screws passing
through the kickplate into adjustable kickplate brackets.
NOTE: Because the ICB427R drawer panels may
extend down in front of the kickplate/grille, it may be
necessary to remove the bottom drawer to gain access.
To remove kickplate/grille, extract screws (two each
side) and pull kickplate/grille forward.
(See Figure 6-30)
Side Molding Strip Removal
(Models ICB427 & ICB427R)
Side molding strips are held in place by four unit-to-cab-
inet brackets attached to the sides of the cabinet.
To remove side trim molding strips
1. Place a straight-blade screwdriver in channel at
bottom of molding. Gently pull molding forward
until face-frame edge of molding is accessible.
2. Place another straight-blade screwdriver under
face-frame edge and gently work molding away
from face-frame, and off of unit-to-cabinet brackets.
Wine Compartment Light Switch & Fan Switch
Removal (Models ICB427 & ICB427R)
The switches protrude through the top trim molding, just
above the door. Tabs on the switches hold switches in
the switch bracket behind the top trim. The bracket is
attached to the switch enclosure with screws.
NOTE: Switch with white back is for the lights;
Switches with black back are for the evaporator fans.
To remove a light and/or fan switch
1. Remove side molding strips.
2. Pull top of top molding forward, then lift up.
3. Extract screws from the switch bracket and pull
bracket forward.
4. Disconnect the electrical leads from the switch
being removed.
5. Depress tabs on side of switch and push switch out
of bracket.
7011544 - Revision A - November, 2008
International W
International W
MODELS ICB427 AND ICB427R
(See Figure 6-31):
(See Figure 6-32):
ine Storage
ine Storage
(ICB400)
(ICB400)
Screw (4)
Figure 6-30. Kickplate/Grille Removal
2
Figure 6-31. Side Molding Strip Removal
3
2
1
Figure 6-32. Light Switch & Fan Switches
6-14
Series
Series
Kickplate / Grille
Unit to
Cabinet
Bracket
Side
Molding
Strip
Top
Molding
Side
Molding
1