100 Hour Lubrication And Maintenance Checks - Komatsu 730E Operation & Maintenance Manual

OM4035.1 01/04
Lubrication and Service

100 HOUR LUBRICATION AND MAINTENANCE CHECKS

Maintenance for every 10 & 50 hour Lubrication and
Maintenance Checks should also be carried out at this
time.
1.REAR HYDRAIR® SUSPENSION PIN JOINTS - (If
not equipped with automatic lube system) - Add one or
two applications of grease to each grease fitting for the
upper and lower suspension mount pins. Use Lube Key
"D".
2. BODY HINGE PINS - (If not equipped with automatic
lube system) - Add one or two applications of grease to
each grease fitting. Lube Key "D" for the body hinge
pins.
3. HOIST CYLINDER - (If not equipped with automatic
lube system) - Add one or two applications of grease to
each grease fitting for bearing and pivots. Use Lube
Key "D".
4. ANTI-SWAY BAR - (If not equipped with automatic
lube system) - Add one or two applications of grease to
each grease fitting for pin and bearings. Use Lube Key
"D".
5. HYDRAULIC OIL FILTERS - Change filter elements
after the initial 100 hours of operation; then at 250
hours; and then each 500 hours of operation thereafter.
Truck Serial Number __________________________
Site Unit Number _____________________________
Date: __________ Hour Meter __________________
Name of Service Person _______________________
COMMENTS
Maintenance - Section 4
Page 4-7
CHECKED INITIALS