Selecting The Group/Channel (Gp/Ch); Audio Attenuator Setting (Af Att); Low-Cut Filter Setting (Lcf); Lock Function (Lock) - Sony DWT-P30 Operating Instructions Manual

Selecting the group/channel
See "Carrier Frequencies and Channel Steps" (page 20)
for factory settings.
For details, see "Selecting the group/channel" (page 7).
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using Cross Remote" (page 8).
Audio attenuator setting
When INPUT LEVEL is set to MIC, select the attenuator
level for audio inputs.
Note
This setting cannot be changed when INPUT LEVEL is set
to LINE.
Input audio from the connected microphone, and use the +
and – buttons to select the attenuator level while viewing
the input level meter.
The reference levels for the various settings are as follows.
Input Attenuation Reference
(dB) input level
(dBu)
MIC 0 –58
3 –55
6 –52
9 –49
3 dB steps 3 dB steps
45 –13
48 –10
LINE – +4
The audio attenuator setting can be changed from the
receiver and other devices via the wireless remote control
function.
For details, see "Using Cross Remote" (page 8).
Low-cut filter setting
The frequency of the low-cut filter can be set.
OFF: Turns off the low-cut filter.
20 30 40 50 60 70 80 90 100
120 140 160 180 200 220 (Hz): Low-cut filter is set
according to the selected frequency.
Using wireless remote control, this function can be
controlled from the receiver and other devices.
For details on wireless remote control function, see
"Using Cross Remote" (page 8).
(GP/CH)
(AF ATT)
Maximum Headroom
input level (dB)
(dBu)
–22 36
–19
–16
–13
3 dB steps
+23
+24 34
+24 20
(LCF)
Lock function
Lock and prevent operations such as those for the POWER
button and for settings changes. This prevents you from
accidentally turning the unit off, for example.
UNLOCK: Disables operation locks for the POWER
button and settings changes.
POWER: Locks POWER button operations only.
SETTING: Locks setting change operations only.
POWER+SETTING: Locks both POWER button and
settings change operations.
Disabling the lock function
Set LOCK to UNLOCK.
Changes to the LOCK function are enabled, even when
settings change operations are locked.
Lock function shortcuts
You can use to the unit's buttons to enable or disable the
POWER+SETTING setting and all lock functions without
displaying the settings menu.
To enable the POWER+SETTING setting, hold down the
SET and + buttons at the same time until the
POWER+SETTING icon appears.
To disable the lock, hold down the SET and – buttons at the
same time until the lock indicator disappears.
The lock setting can be changed from the receiver and
other devices via the wireless remote control function.
For details, see "Using Cross Remote" (page 8).
Note
Changes to settings via the wireless remote control
function are enabled, even when settings change
operations are locked. However, changes to settings will
not be possible via the wireless remote control function on
receivers that do not support the settings change lock
function.
For details, refer to the receiver's operating instructions.
Power save setting
To conserve power, this setting allows you to put all
transmitter functions to sleep.
ACTIVE: The transmitter operates normally.
SLEEP: The sleep function is on. During sleep, the
POWER indicator flashes at 2-second intervals.
To change back to normal operation
During sleep, press the SET, +, or – button.
You can also use the wireless remote control to change the
receiver back to normal operation.
11
(LOCK)
(POWER SAVE)