Setting The Transmission Channel; Selecting The Frequency Band, Group, And Channel - Sony DWT-B03R Operating Instructions Manual

Setting the Transmission
Channel
The unit provides groups of interference-free channels.
When using multiple wireless microphones and
transmitters at the same time (simultaneous multi-channel
operations) within the same area, you must use channels
within the same group to prevent signal interference.
To set the transmission channel on the unit, first select the
frequency band, group, and channel on the receiver using
its RF indicator and scanning functions, then match the
frequency band, group, and channel settings on the unit
with the settings on the receiver.
Notes
• Certain transmission channels cannot be used with the
wireless remote control function.
For details on transmission channels that support the
wireless remote control function, refer to "Sony Digital
Wireless Microphone System Frequency Lists" on the
supplied CD-ROM.
• When selecting the channel, "(INCOMPATIBLE WITH
RF REMOTE)" will slide across the display for
transmission channels that cannot be used with the
wireless remote control function.
• When a transmission channel that cannot be used with
the wireless remote control function is selected,
"RESTRICTED BY GP/CH SETTING" appears on the
RF REMOTE screen and the wireless remote control
function cannot be used. To enable use of the wireless
remote control function, select transmission channels for
which "(INCOMPATIBLE WITH RF REMOTE)" does
not appear during channel selection.
Selecting the Frequency Band,
Group, and Channel
Set the frequency band (BAND), group (GROUP), and
channel (CH) as follows.
For details on groups and channels, refer to "Sony Digital
Wireless Microphone System Frequency Lists" on the
supplied CD-ROM.
For details on menu operations, see "Basic Menu
Operations" (page 10).
Notes
These settings cannot be changed during actual signal
transmission.
1
Turn the unit off, and then hold down the POWER
button while pressing the SET button.
The unit turns on with signal transmission stopped.
2
Use the + and – buttons to display the BAND screen.
3
Hold down the SET button until the setting value
blinks.
4
Use the + and – buttons to select the frequency band.
5
Press the SET button to confirm.
6
Use the + and – buttons to display the GROUP screen.
7
Hold down the SET button until the setting value
blinks.
8
Use the + and – buttons to select the group.
9
Press the SET button to confirm.
10
Use the + and – buttons to display the CH screen.
11
Hold down the SET button until the setting value
blinks.
12
Use the + and – buttons to select the channel.
13
Press the SET button to confirm.
Notes
To start signal transmission with the selected frequency
band, group, and channel, turn off the unit and then turn it
on again.
Configuring the settings via Cross Remote
pairing
When the unit is paired with the receiver, the unit's
transmission channel is automatically set to the receiving
channel on the receiver.
For details on pairing, see "Pairing" (page 8).
7