Table of Contents
Advertisement
Press Apply at the bottom of the screen.
!
NOTE! Once the Apply button is pressed, the gateway WIFI adapter stops sharing the
WIFI hotspot and changes the connection to configured WIFI network. In case the DHCP
is used, the gateway has now a new IP address. This IP address is needed to reconnect to
the gateway, e.g. to check the Status Page or scan the devices within the gateway's
range.
Local IT department can find out the gateway's IP address by accessing the WIFI router
device list or by performing the network scan for IP addresses. In case a static IP is used,
the address is known.
Connect your computer, tablet or mobile phone to the same WIFI network as the
gateway is connected. Open a web browser and type the new IP address to the address
field and press enter. Access to gateway configuration pages is established again.
!
NOTE! If there was an error in SSID, password or IP address configurations, you cannot
access the gateway anymore. In this case the gateway isn't shown in WIFI router device
list or in network scans.
Press the reset button at the bottom of the gateway for 10 seconds to reset the gateway
to factory default values, while the gateway is connected to power.
DOCUMENT ID
4MWA000032
© Copyright 2023 ABB. All rights reserved.
REV.
B
AB B ABI LIT Y™ SM ART S ENSO R BLU ETO OTH ® G AT EWAY
DATE
February 2023
LANG.
PAGE
EN
15/29
Advertisement
Table of Contents
