Advertisement
Mounting and Installation
Step 1: Determine if you need an Expansion Module.
a. An Expansion Module should be added for a second or third coil. Each coil will have temp sensors and a transducer and will be wired to
the respective Expansion Module.
Step 2: Addressing the Expansion Module.
a. Set the address of each Expansion Module using the ON/OFF dip switch bank on the top left corner of the hardware.
b. Expansion Module one must be set to address 1 (Position 1 up), Expansion Module two to address 2 (Position 2 up), Expansion
Module three to address 3 (Positions 1 and 2 up).
Step 3: Install the Expansion Module.
a. Make sure power is OFF to the CC200 Main Controller. Power will be restored in a later step.
b. Install Expansion Module 1 on the DIN rail adjacent to the CC200's right side. The CC200 Expansion port terminals V+, V-, LAN+ and
LAN- will be aligned with Expansion Module 1 Expansion port terminals. Slide the Expansion Module into the CC200 Expansion port
so both device's Expansion port connectors fasten together.
c. If Expansion Modules 2 and 3 are present, connect to Expansion Module 1's Expansion port using the same manner described in the
above step.
No wiring is needed between the CC200 Main Controller and CC200 Expansion Module. Power and communication are sourced from the CC200
Expansion port and passed through each Expansion Module Expansion port.
Step 4: Terminate sensors on the Expansion Module and refer to the drawing and specifications in the CC200 manual for
terminal numbers and how to terminate.
a.
Once all sensor terminations are complete and the Expansion Module Expansion port is securely plugged into the CC200 Expansion
port, restore the 24VDC supply power to the CC200 Main Controller. Once connected, the Expansion Module PWR ON LED will
illuminate green indicating supply power is present.
For
the full user manual, scan the QR code:
Document Part # 026-4715 Rev 6
For Technical Support call the Emerson Support Team@ 479-845-3430or email ColdChain.TechnicalServices@Emerson.com
The contents of this publication are presented for informational purposes only and they are not to be construed as warranties or guarantees, express or implied, regarding
the products or services described herein or their use or applicability. Emerson reserves the right to modify the designs or specifications of such products at any time without notice.
Responsibility for proper selection, use and maintenance of any product remains solely with the purchaser and end-user. ©2022 Emerson is a trademark of Emerson Electric Co.
This document may be photocopied for personal use.
Visit our website at www.climate.emerson.com for the latest technical documentation and updates.
Join Emerson Technical Support on Facebook http://on.fb.me/WUQRnt
Page 2 of 2
Advertisement
