The Settings Menu - Cisco Codec C Series Getting Started Manual

Cisco TelePresence Video Systems
Contents
The Settings menu on the Touch
controller
All settings are not available on all products; therefore the menu
items shown to the right may or may not be present on your
system.
You can find a complete description of the touch controller
menus in the user guide for your video conference system.
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
Settings
Background
Ringtone & Sound Settings
Bluetooth Headset
Camera Control
Display
Main Source Selection
Language
Date, Time & Location
System Information
Call Status
Diagnostics
Restart
Administrator
Configuration

The Settings menu

• Background: Select a background picture for your touch controller and main video
display.
• Ringtone & Sound Settings:
• Bluetooth Headset:
• Camera Control:
• Display: Select brightness, color temperature and dVi mode for the main video display.
• Main Source Selection:
• Language: Select the language for the user interface.
• Date, Time & Location: Configure date and time settings.
• System Information:
•
Call Status: See an overview of the call parameters when in call (e.g. protocols,
transmit and receive rates, packet loss).
•
Diagnostics: Set additional system logging on.
• Restart: Select this option to restart the system.
• Administrator: See below.
The Administrator Settings menu
Back
| Administrator Sett
• Call Details:
Call Details
• Provisioning:
Provisioning
• Multiway:
Multipoint Mode
• IP &
IP & VLAN
connected via lAN there are separate entries for the codec and the touch.
SIP
• SIP: Configure the SiP settings.
H323
• H323:
EMC Resilience
• Web Snapshots:
Web Snapshots •
EMC Resilience:
ience to electromagnetic noise present.
Reset
• Reset:
are reset.
31
Appendicies Appendices
Select a ring tone, the ring tone volume and key tone.
Select a bluetooth headset.
Set the camera parameters.
Select the main input source, e.g. camera control.
See an overview of the system configurations.
Configure the default bit rate and auto answer settings.
Start the provisioning wizard.
insert the address of the Multiway server.
VLAN: Configure the iP and VlAN settings. if the touch controller is
Configure the H.323 settings.
Allow/disallow the web snapshot feature.
Select this option to change the touch controller's resil-
Select this option for a complete factory reset. All of your settings
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts