Cisco Codec C Series Getting Started Manual page 15

Cisco TelePresence Video Systems
Contents
Configuring H.323 and SIP
1.
(when not set by a provisioning system)
to get online and ready to place and receive calls, your system
must be set up properly. Your system uses either the H.323
protocol or the SiP protocol for video calls.
NoTe: Contact your system administrator, or service provider,
for information about the network settings.
for networks administered through Cisco tMS (Cisco
telePresence Management Suite) your Cisco tMS adminis-
trator will help you to get online.
You can find information about admininistering through Cisco
uCM in the Administering tC endpoints on CuCM
Back to task overview
D14639.09 Video Systems Getting Started Guide TC6.1, April 2013.
Introduction User interfaces
H.323
if in doubt about any of the parameters below, contact your
system administrator or your service provider.
1. tap Settings > Administrator >
2. enter the
input fields.
3. if you want to enter the address of the H.323 gatekeeper
manually, tap
and enter the
otherwise tap Auto.
4. if the H.323 gatekeeper requires authentication and you
want your system to authenticate itself to the gatekeeper,
guide.
tap ON in the
Login Name
otherwise, tap OFF.
5. tap Save
saving.
6. review the System information page and verify the H323
settings.
if you successfully registered to the Gatekeeper the
is shown as
7. tap Exit to return to the home menu.
Confirguration Configuration
H323.
H323 Number and H323 Id in their respective
Manual in the Gatekeeper Discovery section,
Gatekeeper Address in the input field.
Authentication Mode section and enter the
and Password in their respective input fields.
to save the changes, or Undo to leave without
Registered in the H323 section.
15
Appendices
SIP
if in doubt about any of the parameters below, contact your
system administrator or your service provider.
1. tap Settings > Administrator >
2. enter the SiP uri in the
3. tap the preferred transport protocol in the
section. if you select Auto, the system first tries to connect
using tlS, then tCP, and finally udP.
4. Select a Proxy Type. Step through the list of available
proxy types by tapping the - or + signs. the default type
is Standard.
5. if you want to enter the SiP proxy address manually, tap
Manual in the Proxy Discovery
Address in the input field. if you want the system to obtain
the SiP proxy address automatically (dHCP), tap Auto.
6. if the SiP proxy server requires authentication you must
enter the Login Name
input fields to authenticate your system.
7. tap Save to save the changes, or
Status
saving.
8. review the System information page and verify the SiP
settings.
if you successfully registered to a SiP server the
shown as Registered
9. tap Exit to return to the home menu.
Copyright © 2010–2013 Cisco Systems, Inc. All rights reserved.
Getting Started Guide
Contacts
SIP.
URI input field.
Default Transport
section and enter the Proxy
and Password in their respective
Undo to leave without
Status is
in the SiP section.