Codan SRx Getting Started Manual page 18

Installation
8
Mounting the RF unit
If you are transferring a fixed station to a mobile
station and you have installed rubber feet to the
WARNING bottom of the RF unit, you must remove the
rubber feet before installing it into the mounting
cradle.
To mount the RF unit:
1
Secure the mounting cradle to the surface with at least
four screws, one in each corner of the cradle.
NOTE
1
If the key is locked to the base of the cradle, flip the key
away from the base until it can be rotated (see
Figure 1 on page
counterclockwise direction.
1
Place the RF unit into the cradle and push it under the
tabs at the rear of the cradle, then hold the clamp against
the front of the RF unit.
1
Rotate the key clockwise, then push the key toward the
base of the cradle to lock the RF unit into position.
Ensure there is sufficient space at the rear
of the cradle to clear the RF unit heatsink.
5), then rotate the key in a
NGT SRx Transceiver Getting Started Guide